Drunkskunk wrote:It should be a bearing, not a bushing. I'd replace it if it doesn't clean up well. Honda dealer should have it, may be interchangeable with a CR60-80 swing arm bearing.
Also, I measured the top tube at 12.5 degrees on my bike, although I have dropped my front end 2cm
hillzofvalp wrote:I'm going to have to re-do the pack because I thought the swingarm mounted where the kickstand mounts.... Weird. In above picture the hole just below the biggest circular punch out is where the swingarm mounts! Weird!
hillzofvalp wrote:I wish I had closeup pictures of the swing arm where it attaches to frame. I'm going to call up my mb-5 parts supplier to see if he can send me the necessary hardware so I can have an appropriate prototype made !!!!
Users browsing this forum: No registered users and 4 guests