Help with sorting out wires on generic controller

Thanks in advance to anyone who can help...

Did anyone else go to the closing out sale at e-cycles in Vancouver? It was like a E-Bike wet dream and nightmare at the same time. Isles stacked with E-Bike goodies at pennies on the dollar. I bought three bikes, five hub motors, six controllers, etc etc. Anyone want a 48V 130 amp controller? Got two EVT lithium scooter controllers.

Anyways, I would like to use this controller for a project...

This is a generic 48V 500W brushless controller.

I looked inside and wrote the labels from the board on the wires. Didn't think to take a pic while it was open...

I have identified the power in, phase, hall connectors

Looks like pink green black might be the throttle as it has +5(pink) TI(green) and ground(black)

That leaves:

DS(white) Ground(black) with a yellow connector
VB2(blue) B+(orange) with a white connector
FV(purple) B+(orange) FO(grey) ??(White) Ground(black) with a 6 pin red connector, only 5 pins used
DSC(blue) SCL(brown) ground(black)

Amazing - any chance you are selling any of the hub motors or controllers you bought : )

I dont want to "speculate" on the wires which could result in damaged items so I will refrain

Hi, at this point I have two EVT scooter lithuim upgrade controllers for sale on ebay. item 201065146110. I may put more items up later.

Thanks

Nice, a bit too powerful for my needs but nice controllers : )