whereswally606
100 kW
Tonight I managed to do a good repair on a geared 8fun hub that I scored from eBay for about £30. I'd like to thank a few people whose advice has been helpful. Neil Paisnel for the advice on impact drivers to open the hub screws without buggering the heads. Andre M for the vodka to clean the wires pre soldering. I think ypedal, lfp or amberwolf for the tip about using heat shrink to pull the wires through the axel and ed Lyen for selling me an evil hub motor tester many moons ago. Any some pics of the show. so anyway I come to test it in the hobby vice using a gng controller and a 48v limn bottle battery. Using the stock colour config the hub barely moves swapping yellow and green the hub is very noisey but moves lots.
Anyone already know the correct config for this combo or have a table with it on so I don't have to test every one and risk blowing the motor I just mended? I realise that over volting is maybe not smart for this hub but I have no other battery (I suppose could run it off my seriesed hp power supply's though)
Anyone already know the correct config for this combo or have a table with it on so I don't have to test every one and risk blowing the motor I just mended? I realise that over volting is maybe not smart for this hub but I have no other battery (I suppose could run it off my seriesed hp power supply's though)