hello everybody. newbie here. i'm in Ontario Canada, 48 yrs old.
i read everywhere, researched until my eyeballs hurt, put all my components together meticulously, and my worst fear came to light, wheel won't turn upon throttle input.
i need help on any set up i may have missed. i.e. i am not sure how many cells are in my battery.
i recently bought:
magic pie 4 vector rear wheel 1000w
48V10AH LiFePO4 battery
Cycle Analyst V3 with Shunt V3
-i hooked all up according to videos and directions.
-i power it up.
-CA receives power
-i set up some settings in CA, i.e. voltage, battery type, and disabled some features for now, i.e. PAS, temp, and couple others.
-CA reads 54.1v 3w
-lights on thumb throttle are lit up, all 3.
-i hear no noises whatsoever.
-i hooked up the wheel usb cable to computer and looked at settings. i set voltage for 48v.
-nothing happens again.
i'm stuck. need help.
thanks
Rob
i read everywhere, researched until my eyeballs hurt, put all my components together meticulously, and my worst fear came to light, wheel won't turn upon throttle input.
i need help on any set up i may have missed. i.e. i am not sure how many cells are in my battery.
i recently bought:
magic pie 4 vector rear wheel 1000w
48V10AH LiFePO4 battery
Cycle Analyst V3 with Shunt V3
-i hooked all up according to videos and directions.
-i power it up.
-CA receives power
-i set up some settings in CA, i.e. voltage, battery type, and disabled some features for now, i.e. PAS, temp, and couple others.
-CA reads 54.1v 3w
-lights on thumb throttle are lit up, all 3.
-i hear no noises whatsoever.
-i hooked up the wheel usb cable to computer and looked at settings. i set voltage for 48v.
-nothing happens again.
i'm stuck. need help.
thanks
Rob