USB programming cable with C965A?

Wretan

1 µW
Joined
May 4, 2015
Messages
1
Hi,

I recently got myself a electric bike with rear hub motor of 250watt/36volts bafang system with the C965A display/hmi.

I really want to set the max speed. Currently it's set to about max 24km/h and I think that that's a bit to low. But according to the manual from Bafang some system doesn't support possibility to change max speed in the basic parameter set up.

Do you think that it will be possible to change this value with a USB programming cable?

Another question, is it possible to by-pass the PAS so that I could use a thumb-control instead of pedaling?

With best regards
Wretan, Sweden
 
Back
Top