I have recently installed a mid drive kit from AFTech which works fine with the supplied throttle.
However I am now wanting to install the Cycle Analyst v3 that I have.
I have throttle from em3ev connected into the CA. See https://db.tt/fOEushAy
The shunt I have connected one end to the CA in the only plug it'll fit. But there is the spare sealed wire on the other end. Do I put a plug onto this to go into controller? https://db.tt/Q7AEAbLx
The controller is a Kelly KBS48101L-L
What do I plug into the spare plugs on the controller, that were previously connected directly to the throttle? https://db.tt/IemrtIxX
3 pin colours black, green yellow.
2 pin both red, one going to the battery +ve and other one into the plug between controller and motor.
However I am now wanting to install the Cycle Analyst v3 that I have.
I have throttle from em3ev connected into the CA. See https://db.tt/fOEushAy
The shunt I have connected one end to the CA in the only plug it'll fit. But there is the spare sealed wire on the other end. Do I put a plug onto this to go into controller? https://db.tt/Q7AEAbLx
The controller is a Kelly KBS48101L-L
What do I plug into the spare plugs on the controller, that were previously connected directly to the throttle? https://db.tt/IemrtIxX
3 pin colours black, green yellow.
2 pin both red, one going to the battery +ve and other one into the plug between controller and motor.