Time for the trails. It will really be a climber.
What type of controller is that? Maybe I missed that part.
I did some runs today to provoke the high current stalling/loss of sync problem, but after I got it to happen, no error codes were shown by the controller -so I am still guessing.
Burtie wrote:I updated the firmware on the HV110 ESC today, now It makes a really wierd noise as the motor starts up, -sounds like some sort of spaceship.
Not very steathy but quite funny! I think the large bell on that HXT 130 makes for a good sounding device
recumpence wrote:Is your motor timing set for "Low"? It should be for outrunners.
Burtie wrote:In the latest version of the CC controller programming software (the one that I am using), the 'Outrunner Mode' is an option in the PWM menu, so presumably it affects the pwm switching rate.
The timing appears as a separate menu with options of: Low, Normal, High and Custom. Presumably this affects the degree of timing advance, similar to a petrol engine.
Users browsing this forum: o00scorpion00o and 8 guests