chroot wrote:@Doctorbass- Which controller recommend for 5403 and 5404 and Edward Lyen recommended me run at 24 fets controller to avoid over stress on the controller like 5303 tend blow up the controller easily.
that is exactly what i got: http://endless-sphere.com/forums/viewto ... 31&t=19719
re the wires, i am thinking to not only ask about 10awg wire but also upgrade of hall sensors based on Lowracer experience:viewtopic.php?f=3&t=24805&hilit=5404&start=45
"BUT, I must admit that in a 5hours test run one of the china hall sensors is broken!
I've got figured out, that the hall sensors, the ball bearings and the axle are cheap china trash!
Now I change the 3 sensors against HONEYWELL SS40,
and I change the ball bearings against SKF 6004-2RS / SKF 6005-2RS,
and I change the axle against a new selfmade 12.9 STEEL AXLE with build-in torque support!"
I dont know what of those things Kenny will agree to upgrade, but one sure thing - i will push hard for those changes. No point to get motors that will stop running after short period of time. little problem for experienced people who can fix it / upgrade it. But like me, i cant do it so i want it right in first place.
Will see where i go with it. But again, our power lies in good amount of orders, so please keep coming