moonshine wrote:Thought i'd verify ice is still making badass harnesses. I went on his website (i forgot the link...it's somewhere in this thread) and gave him a call (his number is on there). He was ready to roll. Just tell him what you want and he'll order the stuff and charge accordingly. He made a 30s2p harness for me so that i would have a wicked simple plug and charge setup. He also used 75 amp andersons on every every connector...SO BADASS. I'll have to post pics later, although, I'm sure ice will have plenty of pics too. Hope this helps.
icecube57 wrote:I'm a real cool dude
GCinDC wrote:nice. i always wondered if each lead had to be the same length. or over such short distances does it not matter?
icecube57 wrote:Im going to start selling 24v Modded Server Power supplies. These are two NPS-700AB in series for 24v 57A. One will be internally DC isolated so the cases can touch without shutting down the units or electricuting you. The units will be heatshrink or taped together. There will also be a fan mod done so that it starts off at a low fan speed and increases as the load increases. The units are adjustable Internally bud Id rather have you tell me the voltage you want and Ill set it for you cause disassembling the unit could fck yp the ground isolation. The power supplies dont have fan gaurds and will chop a finger or cut some skin so I will install one of those on each supply. The (3) 12v outputs will be paralleled 3-12G to 8G. You can run the units in parallel or series. There will be 4mm bullets on the output. If you tell me the voltage I can set the units up to where you can have a custom voltage to bulk charge 6s packs in parallel to . EX 25v gives you 4.16v per cell. You should also be able to power an ICharger or Hyperion Charger to Full Power Charging Specs. Charge current should be around 1400w when bulk charging. You will either have to have a dedicated 20A breaker or figure out a way to run one supply off one outlet and the other supply off a different outlet on a different circuit. This wont be necessary when using RC chargers cause the power supply should draw that much current but bulk charging RC Packs directly the PSU will PULL CURRENT LIKE A DONKEY on ACID and it will possibly trip a regular breaker. I will possibly sell some 1000w setups but this one is the easiest to mod off the shelf.
My suggested cost for the 24v 1400w Power Supply/Charger is about 80$ plus shipping. Considering BMS battery 1200w charger is $139 plus shipping.
I NEED TO KNOW IF THIS IS SOMETHING YOU GUYS ARE INTRESTED IN OR WHAT?
Users browsing this forum: zappy and 3 guests