My shocking charger

Batteries, Chargers, and Battery Management Systems.

My shocking charger

Postby jla » Mon Jul 30, 2012 7:51 am

I recently purchased a new Icharger 106b+ from progressiverc and whenever I use it shocks me whenever I touch it. One obvious solution is to not touch the charger, but since the buttons are on the face it is hard to avoid touching the metal body. I thought it was because I was using it to parallel charge 6 of my 4s 5amp lipos and it was drawing alot of power, but even when charging one individual battery it still shocks me. This shock only happens when charging/discharging and it is more of an irritating/slightly painful tingle than a death zap. I'm worried that this shock might get more violent over time. I also power it with a 350w 14v 25amp psu if that makes a difference.

Is this normal?Has anyone experienced this same type of problem? Is this perhaps a short in the circuitry? What are your thoughts and advice?
jla
1 mW
1 mW
 
Posts: 12
Joined: Sat Jun 16, 2012 12:16 pm
Location: louisiana, US

Re: My shocking charger

Postby jonescg » Mon Jul 30, 2012 7:57 am

Depending on how sweaty your fingers are, even 24 volts can give a tingle. But it sounds like yours are a bit more than this. It could be some kind of induction effect like when you switch an electromagnetic coil off, the resulting field collapse can send a ~60 volt pulse down the line. I also get shocks when I balance charge my packs on my electric motorbike, but then again, I get electric shocks from this bike all the time. It's some kind of capacitive thing :? Either way it's not good. Tried taking it back to the shop for a replacement?
Voltron the Electric RG250 - Dual Agnis, Kelly 1200A controller, 6 kWh of A123 cells from Cell_Man and a shitty old chassis from 1985 :| Top speed 180 km/h, max current 600 A @ 100 V.
VoltronII 8)
Say no to spaghetti junction LiPo! Assembled Hi-power LiPo packs of any size!

Come on Casey! If you want prototype racing, throw your leg over something with lithium in it :D
User avatar
jonescg
10 MW
10 MW
 
Posts: 2068
Joined: Fri Aug 07, 2009 9:22 pm
Location: Perth, Western Australia

Re: My shocking charger

Postby Jeremy Harris » Mon Jul 30, 2012 8:02 am

My guess is that the PSU may be the problem, not the charger. It seems possible that the PSU may have a fault that's making the low voltage output terminals float at around the supply voltage, which is potentially pretty dangerous. To check, put a meter between your household supply ground and the PSU output, with the meter switched to a suitable AC range for your countries supply. You shouldn't see any voltage at all during this test, if you do then it shows a lack of isolation in the PSU that needs to be fixed.
Please ask questions on the forum, rather than by PM, as it helps others and you'll get a better range of answers.
User avatar
Jeremy Harris
10 GW
10 GW
 
Posts: 4635
Joined: Tue Oct 23, 2007 4:15 pm
Location: Salisbury, UK


Return to Battery Technology

Who is online

Users browsing this forum: cal3thousand, dutchlincoln, ian.mich, izeman and 11 guests