A new eCruiser project...
Going for a full suspension cruiser look. 2-80x motors, 2-sensored controllers, 72v-20+Ah.
I measured 2 bikes - an Electra Rally Sport and a Trek Pure - both have a similar feet forward -
flat foot technology - and not surprisingly have similar measurements at all the tube joins.
The rims are 20 bike rims from Matt's rim group sale and will probably fit these Pirelli moped tires:http://www.motorcycle-superstore.com/5/ ... -Tire.aspxhttp://www.motorcycle-superstore.com/5/ ... -Tire.aspx
The board at the bottom of the pic is approximately the ground.
The top of the seat tube is about 27" above the ground - same as the bikes above.
The top of the head tube is about 32" - again same as the bikes above.
The wheel base is about 52". The original wheel base for the Electra and Pure is about 48"
The forks will be Girvin forks - as shown. I will look for a mono shock for the rear.
It's a really long swing arm - might have to add another triangle to support it - but I like this space
for the motor(s).
Going for 72v and 20Ah or more capacity. So what you see in terms of batteries are half for this bike. The other half
will go on the other side of a spine that I will build in the center of the frame. Ignore the HV160 - will go with censored controller (s).
And it's all up for grabs...what do you think?