Recent content by botz244

yep ive been down that road and it sucked ass on the front. used them on the front for like 2 days. a great short term tire. a short tire life and too prone to flats. i killed a rear tire in like 6 weeks 24 miles a day 6 days a week. my bike weighs 80 lbs and im 240, i have a Salsa Ti mukluk and...

24 fet zombiess controller on a 30 inch tire fatbike 98 lbs plus me at 280. no problems

so is this plug and play with the old and new

in down for 6 packs for 18s2p -32 ah oh ya for 2200.00 no problem. for 25 lbs heck ya

i found some spec of the motor type in qulbix raptor with cromotor. or copy and paste...

ive always gone with 14 ga or 2.0 mm spoke with my 3540 and now my cromotor plus im at 250 lbs .with my cromotor bike alone at 80 lbs with the skinny tires and 98 lbs with the fat tires and bigger battery pack ,the wheels have been fine both on 26 in wheels. go with it youll be fine

calculate the spoke length that rim it should say erd ,effective rim diameter on it some place i think it should go radial mounting to

I ,ME ,tOM HAVE A CROMOTOR AND ZOMBIESS CONTROLLLER AND CA3. THE TIRES ,WHEN I FIRST PUT IT TOGETHER WAS A 4.8X26 SALSA LOU.it read fine,or close.now that i put on summer tires the tire is a 3.8, an inch and a half shorter.the measurement went from 2286 down to 2155cm circumference. the only...

now that ive switched to summer tires there smaller and it changes the diametergoin from a 4.8 tire to a 3.8 shortins the tire .ive changed the numbers and the speedo is still wrong i test it with my gps and it says still .,25 mile short per 1 mile.in can change it back to 2259 or way back to...

thanks tekletek yep refreshed it and my v/v values were a little off works great now.yep now at 350 lbs loaded it pulls like a champ.ALSO HAD TO GO WITH THE KW settings to get my shunt reading right. also help with justin thanks. im goin to push it this week to se how many miles i can get from...

well its been while.finally got the program cable for the ca and it came back alive it worked but the voltage now is wack at 124 volt for 18s 3p .i programmed it and everything was good till go back to the screen and its at 124 volts .another thing it wont let me adjust the shunt down to .800 or...

Depents on the weight your goin to be riding and were your riding id still go with a double wall rim plus there in stock.plus cheaper in the long run itll be the last rim youll buy.the rim will be centered on your hub no offset

i just typed 36 hole rolling darryl and it came up 162.00 and there out of stock. you have to use the internet

mitch just do, i have. to all the non fatbikers out there if you dont have one ,you cant talk. ive had mine for 2 winters. Ti Mukluk 4.8 tires on 80mm rim36 holes with a Cromotor 24 fet 20s2p. they do have 36 hole wheels even in 100mm wide but i went with 80 and mine are double wall. my bike...

its impossible to use the CA as there is no display to see.yep i have taking the whole thing out of service and have planned a kill switch, move it from the controller to the handle bars. i do have a stop switch on the throttle and that still goes thru the CA. but that will changeto the...