Recent content by Daxxie

I used these Lekkie adapters on my last bike. Cheap and worked great. Lekkie 41mm Press-Fit Cup - Lekkie

Great work. Flashed my BBSHD (V1.4 STC15W4K56S4) Worked!

I still have a couple available. PM me

Why? You dont have to anymore. There is a solution for that.

No don’t worry about it. Lots of people did it without a problem.

There is no torque specified for this bolt. Probably around 6Nm + Loctite. The carbon is threaded. So don't overdo it!

Also got this set in 27.5x4.5 FAT 45NRTH Vanhelga on 80mm Mulefut wheels. No chain rubbing. Very agile. Almost a mountainbike. These are my favourites.

Tried these nobby Schwalbe 26x4.8 Jumbo Jim (26X4.4 rear) The 4.8 looks massive on a 100mm rim. At the back I've put a 4.4 (chain rub with 4.8)

Tires Fat Bike Apache Fatty Slick 26 x 4.5 They look cool but drive like sh*t! Too much selfsteer. Bike doesn't feel safe. The rims are 100mm Clownshoes and a 4.5 on a 100mm rim is too wide. I can't select first gear (chain rubbing)

Cockpit: The innotrace motor comes with an optional X1 display (Looks like a Bafang SW102) It has a hidden lock/unlock 25km/h function. I like a left thumb throttle but it doesn't match very well with the display. Some adjustment is needed. Note the dropper remote. Everything into the...

I think mine is also on its way out. What symptoms did you have? Planning to change all bearings on the axle.

I gave you the schematics. https://endless-sphere.com/forums/viewtopic.php?f=6&t=96212&p=1660492#p1653477 Best way is to open the CA and make some custom wiring.

Assembly time First had to calculate spoke length Order spokes and nipples and lace the wheels. Surly Clownshoe 100mm Hope Fatsno Pro Hub 150/197 Install the Cane Creek headset. Placed a gear sensor (in the frame) Looking good!

Made some templates And off it went to the paintshop https://d-ecustomworks.be/fietsen.html I chose for Cerakote Tungsten Grey for the frame Wheels in cerakote Burnt Bronze (Surly Clownshoe 100mm rim) Looks good!