Recent content by Dylandesmond

Thanks john , i ended up getting a higher voltage controller im pulling my max of 480amps when its fully sagging at 115 v so im not quite there, carbon bars are holding up fine, i blew an air line on one of the rams last week qhich scared the shit out of me, lucky in was further down the road...

If its torque sensing that should be fine because itll do a analog voltage otherwise its pulsing,,, if you're lucky it might match up, somehow i doubt it ive only converted a torque sensing one, the servo tester just converts it into pulses for the esc to know what to do, i had mine setup as...

‎https://www.google.com/search?q=ebike+throttle+servo+motor&oq=Ebike+throttle+servo+&aqs=chrome.1.69i57j33.16178j0j7&sourceid=chrome-mobile&ie=UTF-8#scso=_JSUsXMzsBcOa8wWF-Ydg22:502

‎https://m.youtube.com/watch?v=hOI7-slS6wg

Hobbyking sell them there are videos onyoutube

:bigthumb:

I bumped it as a joke, i knew it was a really old post, was to get people laughing not crying, sorry if i hurt anyones feelings lol i decided to post up this 60kw thread after seeing it as their is alot of knowledge that i dont have, safety sides of things and getting the right products is...

Apples to oranges

Get a kelly controller a non geared hub with ferrofluid works fine atf has alot of rotational weight id rather that weight copper and magnets

Or dc to dc converter if charge amps has a limit you need to follow

Use 72v mppt or pwm deep cycle directly into bms

What about insulation？ peltiers arent that great on efficiency insulation with simple lightbulb and tiny fan inside box would be a better use of power peltier are 5％ efficient making cold when its hot ambient temps its the same in cold situation （not as bad but a waste of time） an arduino...

Your motors stomach is hungry

Works with servo motor tester

6380 skateboard motor Max Torque = 5.06Nm Max RPM = Voltage * KV (170KV) Motor Weight = 2.25 lbs