Recent content by Etni

Hello! Googling around for KT controllers, I've found out that they come in about a million different specs, features and cable configurations. Browsing sites like aliexpress is kind of difficult because each store sells only a few different models and often with less than complete...

Awesome! Thanks a lot for the link, I’ll look into this.

] Well that’s why I asked - because I’ve gone through the settings and haven’t found anything obvious besides C13.

In my case (OP) the brake at max setting is too strong for me to use at high speed, because with this controller the brake is just 2 wires, on/off. I’d imagine some other controllers have 3 wires and can adjust braking strength based on lever position. Anyway, the max setting almost throws me...

I'd like to put a high-capacity battery on the rear rack of my bike. I've been googling for battery cases for a couple of hours, trying to find something that isn't narrow and tall like the bigger Hailong cases, but haven't found anything useful so far. Hopefully I just suck at googling. Any...

It's doable, I've used this cable for charging my battery-upgraded Onewheel with two stock chargers: https://two-x.com/products/charge-x . However, you can't just connect two chargers directly in parallel, it needs to have some kind of circuitry, but I can't go into specifics because I don't...

That sounds more useful than mine. What's the model of your KT controller?

Yes, no brakes with a 100% full battery is one drawback, no brakes in case of any motor/controller failure or disconnect is another. But, based on my experience with electric boards and other vehicles, powerful motor braking seems very much possible. It can also be done at very low speeds by...

Hello! I have a 26" 1500W hub motor and KT-LCD8H display, and I installed a controller that supports regen (kt 48svprl-sls02g), hoping that I could use the brake lever for motor braking. The brake lever now works, and I can adjust the braking strength with setting C13, but even on the...