Recent content by GaSSoo

So I managed to set parameters somehow. It's pretty accurate to GPS. Sometimes when I pull off throttle and the bike starts to slow down, the display shows a speed of 42+ km/h and then it shows again right speed. Is it possible to tune pas sensor? 1-2 is fine (17-22km/h) but at pas 3 It goes...

You can't see it much, but you can definitely feel it vibrate. I used tire sealant to prevent flat tires. Can this unbalance wheel?

Hi, I recently noticed vibration from rear wheel. When I lift wheel and slowly move motor with throttle it starts vibrate. When motor spin fast it vibrates whole bike. I made video. You can see freewheel floats little. I think there might be something bent. When I first got bike it arrived with...

I noticed when using PAS it gets full power no matter what pas level I select. Can I set it somewhere or what can I do with it please? There's so much problems with this controller swap 🙁 Here is my settings.

Ok thanks, I'll try it and let you know. I have one more question. This motor has 80nm. of torque. It was a nice hill climber and could get to 30+ mph. But before that it used a 22A squarewave controller. Does this torque change with a sinewave controller?

Yes controller have also 9 pin. I have everything connected it just needs to set parameters. I know number of magnets is 12 so should I work with this number? When it comes to wheel diameter. I counts only rim or is it calculated with tyre?

So to give little update. I bought KT controller with LCD8HU display and changed throttle and brake sensors. But need help to set parameters for motor. P1 and P2. Everything I know about this motor is it have 12 magnets. And it's 750w Brushless Gear Hub Motor . Manufacturer won't tell or don't...

Ok thank you very much. I hope it will work without problem.

I don't have multimeter but I found red-red and black -yellow works. But it also works the other way R-Y and B-R. Does it matter how I connect it? Can I connect third wire also?

Hi. I'm trying to connect brake sensors to kt controller. On 1t5 cable brake sensors is 3 pin male. But my brake sensors connector is also 3 pin male. Cannot find sensor with 3 pin female so I bought 3 pin female connector with 3 wires on end (y, r, b). I cut brake sensor and there is also 3...

Yes it is a e-bike. It is much better now. It is more comfortable thanks to better suspension and more controllable thanks to wider handlebars. This is how it looks like before.

So I made it. It was little dificult but I like to try new things. So thank you guys for help.

Thank you. I prepared for it to install cups and crown race. I hope everything will be ok.

Ok so I removed that crown race with effort and hammer but it is done. I messure ID of frame head tube and it is 44mm. Will this headset fit?

I have little problem. I tried put crown race on new fork but I was stupid and do not mesure it before and now it is stuck and it cannot go down or up. I do not know how to remove it.