Recent content by GiantEV

Very well done!

Mine was snappy with my mini-e but I was also running a 20" wheel. I recommend working on tuning a little more.

I bought it built like that from MXUS.

Great, thanks for the suggestions guys.

Thanks, striker. It looks like I'm not the only one having this problem. I remembered that you could disable charging through the menu so that's what I did. I also have the on/off switch on my Max-E, so that should work as well, but I won't know until I wire in a switch (on/off wires come from...

I'm having a problem where I can't exit charge mode on my Max-E. With my Mini-E I just hit down to exit after turning off the power supply but my Max-E stays in charge mode. The down button works in other screens, just not to exit charge mode when I'm done charging. I can disconnect power after...

I have the MXUS3000 3T "Fast Wind" motor in a 20" wheel... I have so much torque available that the bike is almost scary. Also, regen is very powerful as well, which is easily setup in the Max-E controller. For the price, I'd say the MXUS 3T motor can't be beat. I cruise at 45mph (on a closed...

I'm looking to build a couple of front wheels that need to have 20mm Thru-Axles (TAs). I bought a Hope Pro 2 EVO hub for one of the wheels and am trying to decide if I want to try a cheaper hub for the other wheel. So my question is, what experience do you guys have with front hubs that are...

No, I used sine wave for autodetect. I also ran autodetect twice, which can help sometimes, but all that did was get me close. I changed the settings to what I was running on my Mini-E and the Max-E is running much better. I still think there is some room for improvement in the tuning though.

Thanks guys! I need to tune my Max-E a little, but it still pulls hard with just the autodetect.

I bought a Vector frame and moved most of the components from the Metro over to the Vector, so I'm retiring the Metro. Here is my new Vector build thread: http://endless-sphere.com/forums/viewtopic.php?f=6&t=69482

Reserved

Here is my new build... - Vector frame - MXUS3000 3T motor in 20"/16" wheel - Adaptto Max-E Controller + BMS + PAS + ON/OFF + 30A coil - (20) Turnigy 4s Hardcase Batteries in 20S4P configuration (20Ah) I got it running today and took it for a ride, but still have some work left to finish the...

Are you using spacers? How are you routing the rear brake line through the frame? I'm mostly concerned with how it enters the front of the frame since there is a hole at the rear of the frame already.

Ok, John, I'm holding you to it! Did you make any progress? If so, when will they be for sale? I was planning on sending out my wheel to be built, but I still have this strong desire to attempt a wheel build myself. I already bought a Hope Pro 2 EVO 20mmTA hub and a ProWheels 19x1.4" 36H rim...