Recent content by gip_mad

Exactly. But we need AN-11 to check this....

Hi, thank you for the updates, it's very interesting. It's a bit sad that one fet was defective on each board... Btw, I guess that they tell you to remove the cap because it could couple some AC voltage to the unused cell pin, making it sense a cell and go crazy.

Hi guys, sorry for the delay. Here is the software, but I can't find the "clean" DS anymore, so if someone can post it for me it would be great. I will look into it this weekend if needed, as I'm currently out of free time. :( Bye

Just hold on a few days. I don't have access to the original files ATM. :D http://endless-sphere.com/forums/viewtopic.php?f=1&t=25629

You can try to build a parallel port adapter for free!

Here's the datasheet. Password is wizardofoz Have fun! 8)

Probably it's only the I2C part of the OZ that is "disabled" at power on. The OZ can work in I2C or in standalone mode, so maybe it starts with the latter by default. I have the DS but it's signed, if you know a way to remove text in bulk from the pdf pages I can upload it here, else just ask me...

I just downloaded the file, and I can't see the interface too. I have this version, wich is a bit older, but let you choose the parallel port adapter or the AardVark from the settings page. Hope this helps! Let us know about your progress! :D

You can find all the register mappings in the files inside "C:\Program files\O2Micro\CowBoy\Configurations\". Look at scan.cfg: 8)

No problem! :) Just let us know if you manage to make something out of it! :)

Just checked, it's in my "sent" folder, so it must be a problem on your side.... the mail is d s d a v o r i n right?

Hey, I sent you the program via mail, but I didn't get any reply from you; are you sure it didn't go to the spam folder??

I have a datasheet. I have the PC control App too, where you can find all the I2C registers and their meaning. Here's the pinout!

Sent you a PM :)

Hi, I have 2 of these BMS too. I got my hands on the programmer, with all the i2c parameters addresses. I2c should be on pins 3 and 5 of the 12-pin connector on the edge of the board. I don't have a lot of time to experiment, so if you want it just pm me. you can communicate with the program via...