so, this might be a stupid question but i am a bit confused about the pas configuration possibilities with "stupid" magnet pas discs
currently i am using a 12 pole pas device in basic mode with rpm downscaling, which works but i think this maybe can be improved. i stumbled across the pas mode...
Hi!
i just upgraded my CA to 3.11 and had some (new) strange things happening. After flashing the newest firmware it seems like the CA or at least the serial com interface crashed, i was not able to read/write anything from/to the ca. it always ended up in a timeout. sometimes writes where...
Hi!
i am corrently using a 12T Mac Hub hooked up onto a 12 Fet EB312 Infineon Square Wave Controller which performs great except its noise. Especially during start the Hub makes a grumble noise until it reaches 5-6kmh. I dont think that this noise is generated by the planetary gears, correct me...
:( but yes, i understand your point. in one of the older firmware releases the CA showed a factor 1x 1.25x and so on, do you remember in which version this has been changed? maybe i am going to downgrade to that one
Heyho :)
can i somehow hide the display output when using the analog poti + pas factor? i dont want the ca to display tons of watts while turning the pot, this could be very hard to explain in certain situations (EU 250w Limit).
Cheers!