Recent content by Jpwcamel

Found solution :)

Interesting, could it be a failty controller than? I’ve vitrtually tried changing every setting, nothing helps it.

So after some more speculation and pondering, I’m pretty sure what I feel, is because the controller is a square wave controller.

Yeah.

I’ve gone through value 3 through 7 and non of them made a difference unfortunately.

So, I’ve managed to narrow down exactly what’s happening. With PAS the bike seems to almost be limited to 2 kilometers below what I’ve set the max speed to, making the bike stuttr when hovering around that speed. However if I apply the throttle the bike has no issues reaching the set max...

I haven’t tested this yet, but I’ve made some new discoveries. When using the throttle only, the bike runs smooth, no jerky / jumpy movements. I’ve found that when I increase P1, the jumpy / jerky movement gets less noticable and the bike has no problem hitting the set max speed, which is...

So I’ve just done a few test rides, the bike sort of jerks when it hovers at 24-24.9kmh but once it passes that speed its riding smooth again. Soo freaking weird.

Will do when I get home and update with the results.

The jumpy/jerky behavior seems to get worse the higher c5 is, 3 seems to be the sweet spot but than the bike struggles hitting max speed, at the slighest wind. The max speed is capped at 27 because I live in the EU and anything higher would make the bike illegal.

Hey! I’ve recently changed my display to a kt-lcd8h, and after programming the settings my bike gets kind of jerky at around 15mph/25km/h almost like the motor cuts out for a fraction of a second and back on again, this wasn’t a problem prior. From what I can tell the motor wattage kinda jumps...

It’s an integrated sensor (i think its called), there’s just a single sensor / ring, it’s a 12 magnet sensor.

Hey! I’ve run into a weird problem with my ebike, the pedal assist will work when first turning on the bike, but after a few seconds it’ll start cutting out and then completely stop working. The sensor is consistently showing a green LED light, and it’ll faintly blink when I turn the cranks...

A little while after it fell over but before I sent it to the mechanic. I’ve looked at motor cable and from what I can tell there’s no damage to the wire, I had a look inside the motor yesterday and it looked fine, no apparant damage / loose wires.

It’s a kt-lcd8 display, I’ve tried changing the display with no luck. Yesterday I looked into the motor to see if a magnet had gone lose or fallen off, and thats not the case either.