Recent content by Julius Dades

Bafang PAS wires: 1. Red cable - goes to pin 11 of ASI bac855? 2. Black cable - goes to pin 16/? 3. White cable - which pin no.? 4. Grey cable - which pin no.?

Hi, what about for throttle??

It works with mine. I guess swapping the phasewires will work too.

After some trial and error, I manage to figure it out: 1. Red - Red (5v) 2. Black - Gnd 3. Grey - YELLOW hall sensor 4. White - BLUE hall sensor 5. Blue - GREEN hall 6. Purple - Temperature sensor Give that a go. If your mid drive reverses and struggles to spin , play and swap it around...

Does anyone on this forum know what is are the color references of the 6 pin hall sensor on the bbhd controller?: 1. Red - 5v 2. Black - ground 3. Grey ? 4. White ? 5. Blue ? 6. Purple? My is guess is the grey, white, blue, purple are your yellow, blue, green is your typical hall sensor...

Hi Everyone, Recently connected my sabvoton controller with the Cycle Analyst with Grin Shunt. Everything is working ok. Except for when you reach the speed above 25km/h it crates an abrupt/jolting operation on the pedal assist. I didn't experience this when I was using the...