Recent content by Kevinator

Thanks guys! Gonna give this a try in a couple weeks.

OP, how did the repair go? I have a Ping battery that has some bloated cells that need replacing, and was looking for details on how others removed the solder blobs on the pcb. 😁 I already ordered a 80w fat tip soldering iron http://a.co/d/5cE6V6J Reading through the thread, it appears...

Thought this one might work but upon closer inspection, even the gap left by the display doesn't appear to be enough clearance to fully cycle the trigger shifters...

Here I am again 8 years later because I want my trigger shifters to work like normal damnit lol :D This was the solution back then, which was to use the rear shifters on the left side, and lose the front shifter altogether: Anyone have an updated solution so that we can run our trigger...

This is a Motobecane Phantom Elite DS bike with a 900w Cyclone 3-chainring kit. I've managed to slap everything together so that I can blast around at 35mph but there are still some bugs to be worked out. I've got to find a decent spot to mount a controller, and I will probably be replacing...

It came with my Pegasus Power Systems 36v/22a hub motor kit. It is physically the same size as the e-crazyman 24v/18a controller next to it, except the mounting tabs were bent back to fit into the battery case that came with the kit. I think most of the controllers out there are using the...

I sent Golden Motor an email about my wobbling new hub motor a week ago and haven't heard back yet. I think the bearings were pressed in crooked on both sides. In the 2nd video I demonstrated how the side cover spun crooked when turned by hand. With that side cover pulled out like it was...

Ouch Adrian, your description paints a very vivid picture, and those snapshots of the broken hubs in your link sure does back it up. Thanks for the info, glad to know you didn't get run over by a car! I had concerns about something catastrophic like that happening. I have experience with...

heath, much thanks for confirming that the bare wire isn't used in this setup.

well, I hooked everything up and went for a ride. Everything worked as normal so far.

BTW, I noticed that I have black metal gears in the gearbox.

Ok, I got the cover off, and began to attempt to remove the circuit board from the clips inside the motor casing. I decided to take another look at that loose wire. I yanked on it to try to see what color wire it was, but as I pulled on it more, it became apparent that someone must of snuck in...

Ok I found this very useful and awesome post by rkosiorek loaded with pics by Bill Bushnell. Thanks Rick and Bill! http://endless-sphere.com/forums/viewtopic.php?f=2&t=8621&p=131210&hilit=cyclone+internal#p131210 I should be able to take the cover off and hopefully figure out which wire was...

I've got a loose wire coming out of my 900w cyclone motor. Unfortunately, this loose wire appears to be the one that contains many other smaller wires. I can see a few silver strands sticking out that are loose. I'm assuming these wires are for the hall sensors and the other 3 thick wires are...

I haven't worked my way up to big power yet, so I've just been dealing with these average controllers. My 900w cyclone kit is awesome, but as you can see the controller is at least 50% larger than the other controllers (unfortunately in the wrong direction) and its 100% heavier than any of the...