Recent content by kneedeep

I am running low amps so the plug does not affect anything on the rear wheel. I decided against the battery disconnect and went with golf cart power solenoid for 48v and it has been flawless since the change. Personally I would buy the tire you want and try it for fit then sell if does not work...

230mm was way too big. and 200 too small. It called for 210-220mm I used fox float R to get my exact height. Go through my thread that shinko did not have a lot of room left. you might get that on if you shave the side tread. That is what I did to get the current sport tires on.

A lot of time and effort could be wasted learning how to set the time on an old camera. I did not.

Pictures of today's condition.

Pics

This is going in the for sale section $1400 CAD no shipping.

Side panels are not waterproof. I have not fixed the swing arm yet.

page 5 of my build thread says how I did it.

2.25X17 SHINKO SR704 is the tires

2.25 tire. 1.60 rim would be fine that is what the front is.

I am looking for a good price on 17" rim for my next build. More moped duty then motorcycle but best price, not a lot on ebay. want to order so I can order spokes 36 Hole preferred but am doing custom motor and can make any configure work. Any good sources?

No I have not, but it drives very well (on road).

Well another year in the books. This year ended same as the last with a flat tire then snow came. The bike is in the shop ready to get some TLC and i will start my new build soon. Phoenix https://endless-sphere.com/forums/viewtopic.php?f=6&t=96216 . I put another 7 or 8000 km on the bike...

What should I look for in a controller? I will be using a hub motor from Emmo GT80, was running 80v and 30 amps 2000 ish watts and 10" wheel. The Plan- I will be mating this to a 17" moped rim and light motorcycle street tire. No real specs on the motor brush-less direct drive. I will run...