Recent content by maincraft

Hey. I have FarDriver 961800B (Encoder) + 138 90h 4kW + Gear Ratio x80 (Encoder) and 20s 600Ah battery 2000A (Current) Please give me all settings that can make for me MAXIMUM TORQUE POWER FROM 0RPM+ thank you

PID settings changes are work? when changing to chinese ?)

Is anyone know UART serial data protocol FarDriver?

Your problem with contact of Thottle. Check your wire better.

Hey brothers., hey @BareKuda Can any one explain exactly about "Start torque" and "Combinative torque"? I have some problem with another UTV without reduction gear and low throttle (10-20% of throttle). VOTOL waiting some action for move and after due timeout 5-10sec and going to similar like...

Hey BareKuda, i will do full tests in next 1 month.

Hey, BareKuda :)

Yes, also you must set on Current Limitting on Page2 to 50A

Busbar - 150A Current-limiting: 280A

Hey! I have battery with continuous current 750A (5x150A BMS with shared capacity 250ah) I'm looking settings for a full power performance my QS 138 90H (4000W) 1) Whats is maximum Busbar value for EM200SP on Page1 (72V) 2) Whats is maximum Current Limiting (A) for EM200SP on Page2? Thanks!

Hey brother. This is not a standart CAN Protocol Communication. This is simple RX/TX converted by TJA driver

I have catch this settings from notebook of Engineers SIAECOSYS on youtube: But dont understand why: Section #2 is 1000 and Mid Flux-Weakening value is 5000/15?... :idea:

Don't understand question? Just connect plus to plus and minus to minus And you will have shared capacity

Hey brothers. (specially @BareKuda) I have: 1) VOTOL EM-150SP 2) QS MOTOR 138 90H - Rated speed 4000RPM - With Flux Weaking 6500RPM 3) My battery is 72V 200A BMS 4) I need fullpower on rated speed <= 4000RPM and 4000RPM-7000RPM with lower power. I have technical sample about Flux Weaking...

Nop. Brother. Doing it like a hobby project :D