Recent content by Orange_Crush

For now I know enough to change it from analogRead to digitalRead functions to use a conventional magnet brake sensor (plus a pull-up resistor) to act as a safety cutoff and add a 3-pos switch to adjust the analog throttle signal as a basic 'assist level' control (0%/off in pos 1, 50% in pos 2...

Started this thread as a small experiment log/report, trying out an stm32-based m365 scooter controller with stancecoke's EBiCS firmware port on a geared motor bike build (xf19) aiming for 20-25A initially, throttle through an esp32 as laid out on the firmware's github page. A 3-position switch...

Perfect, thank you very much for the reply and clarification -I wasn't aware the configurator was working for the m365 board yet, that's great. I'll start another thread- I do have a few other questions, sorry for the minor hijacking.

I'm working at making use of this controller on bike with a small space for a controller, waiting on Ali shipping now. A few basic questions, if you don't mind: does the firmware use torque or speed-based throttle control (I know torque is the default on ebics), and after adjusting the...