Recent content by Piorun

You could put gasket sealer around the edges of housing to help with water situations.

Honestly, I prefer no sensor. a twist throttle and freewheel. It meshes well I don't need. It is just extra to have. But can be nice maybe to turn off brain and just bike. Right now I am using a 1680w cyclone kit. If you want to talk about noise, I think the new cyc should perform well. The...

I have now tried out a hub motor of slightly less power then my mid drive build. I've road both. Where I feel a big difference, well for one. I feel more comfortable climbing and off-roading on a mid-drive. Speed on pavement or asphalt. Well, I think a hub is really nice all day long. Over...

Alright, Going to mark this as solved. Had some free time. Took the chain off and was prepared to unplug battery and throw it if it exploded. :twisted: Reading a bit more I changed the Green to wire to the white. I kept the two pin connector. Now I upgraded my bike basically I now have a...

The micro switch works. When I turn it on, the Red LED attached to the controller turns on briefly then off. Reading the Kelly controller spec sheet the red LED turns on and then off with no Error code if controller is working fine. The Throttle input does not get a response from the motor. The...

Voltmeter your cells. Write down the Voltage on Every cell. Get a small usb charger to charge any low cells and rebalance the pack manually. Eventually you'll have to rebuild the pack if one cell doesn't hold a charge as long as the others. At that age, I'm sure it's fine. Untill it starts...

Hi guys, I have an older kit, Cyclone 1680w with a KBS48101L controller. with a OBO twist throttle. Recently the throttle no longer works and I cannot find a replacement with the same wiring. The controller gives me a Red LED and turns off with the old throttle wired up. Clearing an OK on...