Recent content by Solaire

I use both a steel freehub body, and a sunrace CSMS8 cassette. It has the six largest cogs on 2 aluminium spiders to reduce the indents. I think just the steel freehub body change should be enough. http://www.sunrace.com/en/products/detail/csms8

My crank bolts have a stamp inside the allen socket - M12 I assume this is what i would need to replace https://www.ebay.com/itm/Truvativ-M12-Capless-Steel-Crank-Bolts/302916381265?epid=1300141998&hash=item4687392a51:g:rAkAAOSw0kRbvkj7

I used a 18650 battery bloc battery in my soft ebike bag last year for about 6 months, mainly dirt roads, and it didnt loosen. One tip i have is not to overtighten, i slightly dented ALL the negative terminals on my 18650s and i did not believe at the time i was overtightening as i was being...

Just spotted the schedule this morning. http://www.sfoadventure.com/about-the-lost-sierra-expo/ 7/12/2019 to 7/14/2019 From last year i assume 7/13 practice day, 7/14 Race day Heres the deal from 2018, probably no change...

I purchased one of the REVEL kits yesterday, and i like it. It uses a Sempu TS Bottom bracket, and has 160/240/320 watt settings, which seem adequate for mountain biking. They can probably set it up however you want. Its bolt on, I had been looking for about the same thing you are looking...

https://www.e-bike-technologies.de/index.php/en/cycle-analyst-v3

I m considering getting one of these for on/off, as i m doing a lot of short trips a day. http://www.nexusmodels.co.uk/sps-safety-power-switch-70v-100-200a-battery-esc-isolator-a72011-emcotec-irc.html http://wiki-en.hacker-motor.com/index.php/SPS_SafetyPowerSwitch

I believe the BBSHD has a max torque of 160nm, and the CK ringdrive is rated to 1085nm according to their website. The biggest issues i have with the CK hubs is the soft aluminium driveshell that comes stock. Cheap steel cassettes with individual teeth will chew that thing up notching the...

For chainring position, i measured from inside of mounting plate to center of motor freewheel teeth, getting 20.4mm and set my motor chainring also 20.4mm from inside of mounting plate in the middle of the wobble( i put 2 X 1mm spacers between the plate and BB cup). I have about 1mm wobble also...

better shot of the Typhoon, it looks like a fun bike, i was hoping for a test ride, but nope.

a couple more

Drag Race Winner?

Hpc tent.

Heres the typhoon after 1.5 laps on bare metal.

+1 megaionlaunch