Recent content by sviatpizdat

These gears. I found on Aliexpress. for 7dollars. Cyclone-TW wants 55$ and 75$ for shippingo_Oo_Oo_O

Does anyone know the exact dimensions of Cyclone nylon gears? I want to order some from Aliexpress. They are much cheaper there and shipping is more convenient to my country.

I think I have found the cause. At a voltage level of about 3.5V overnight four of five cells discharged 0-0.003V, but the last one discharged 0.016V. That cell draining the whole parallel. On Monday I will check the discharge rate again, just to be sure. The battery shop is not working at the...

Noted. But could you explain mechanism around this feature? Should I charge it completely, or voltage drop will be observable at any voltage? Currently 11th parallel is disconnected and at ~3.5V, so could I observe from here? What the problem may be in that BMS?

I usually disconnecting charger immediately when see that the battery is charged. It keeps balancing when disconnected, if that's the issue.

Hi everyone! I have a battery 16s5p of Samsung 30q. After half a year of occasional usage (about 20-25 full cycles) I found that, when the pack is fully charged, the 11th parallel is 0.25V lower than the highest one. When balancing turn-on, it balances to 0.2V (at about 4.1V of the highest...

Thx, @amberwolf! It helped. I've removed an outer seal by prying it out from its outer edge with a very small screwdriver. After that everything is held up by the retainer rings. I was preparing for these temperature tricks, but bearings are rather loose-fit than a press-fit. Some of them just...

Hello everyone! The outer shaft of my Cyclone 1680W motor developed a little play. The internals of the gearbox seems to be good - no teeth wear, no play in the satellite bearings. I think the bearings of the outer drive shaft may be worn out. And I need to replace them. Does anyone know how to...

hi! where i can find motors spreadsheet?

Hello! Does anyone have spreadsheets or some graphic charts test of 1680w motor? I can't find nothing I run at 60a, 48v. After 2000-3000km, my gearbox gears became asymmetricaly worn out. Than a bought a new gearbox. All was great, but after 300km, my some strange sound appeared((

Update!!! I bought a new gearbox from cyclone-bikes.tw I use best grease Total altis sh2 All was good, but after 300-400km a new strange sound :warn: appeared: https://drive.google.com/file/d/1SmdandNeOfL0nelaF_FwOxiocKy4efC9/view?usp=drivesdk the gearbox is new, and not worn out. So...

metal gears!!

Hello! Why mobilith shc 100 instead of shc 220 ? shc220 has more suitable speed and temperature parameters.

Which bearings are used in gearbox?(type, size?) You ordered new metal gears from Taiwan?

Really? What oil you recommend? Is oil not too muth liquid?