Recent content by Tpesl

What is the least amount of wires that have to be connect to the bac 2000 to get it light up? And which ones?

Building a dirt bike with Kelly KLS 72601-8080I controler Performed the initial "setup" by entering #170 in the "motor identify engle " and now the motor spins momentarily every minute or so but nothing else . The throttle doesn't work. Not sure how to proceed. Any ideas? please and thank you.

Hello I'm wondering anyone would be able to solve my problem . I have received a new bac855 i tried installing some of my older Parameter files that I have saved from previous bac800 , I started getting lot of errors and now it won't connect to the app at all. I even tried on my laptop (USB)...

Hello I'm wondering anyone would be able to solve my problem . I have received a new bac855 i tried installing some of my older Parameter files that I have saved from previous bac800 , I started getting lot of errors and now it won't connect to the app at all. I even tried on my laptop (USB)...

Why number of pole pairs at 88 ? On bac800 the setting is at 4 pole pairs for BBSHD

I'm not sure that when you buy bac800 from Alan if one should expect to also receive the code to change some parameters of this "programmable controller " but I have been asking him for months and months and nothing. Does anybody have one (if that would work on all of them.)because I will be...

Say I want to run two battery packs in parallel,both new from identical cells one is 14s10p the other 14s12p . Would there be a problem or should both be the same “p”

So I just installed this new bms on my 20s10p 3500mah cell battery, what settings should I change if any

You probably right Sent from my SM-G965W using Tapatalk

I currently have a mid drive I would like to add front hub for an AWD.I can get a great deal on a rear hub Bafang RMG06 ,is there any way to make the rear hub work on the front?

What’s the highest volt battery you can use with the ultra ? I heard that you could go up to 60v with the stock controller. Not sure if that’s tru.

Thank you for the clear answers. My bike is aluminum and yes I will have a local shop do the welding. Also question about the “tilt” of the motor, Should the motor be somewhat level or the front tilted up more for clearance? Also do you think I would be able to cut the chainstay just in...

Thanks for the instructions very informative , i’ll be doing the same thing shortly , my question is do you find that it’s absolutely crucial to have the Bottom bracket at exactly the same position as it was before I can’t see that it would make such a big difference if it was slightly forward...

So I have this controller coming -ASI BAC 800 FOC Bluetooth 72V 96A to go with my BBSHD, I will be building 19 or 20s10p pack from LG HG2 cells ,these cells have 3000mah and 20a discharge, I need some advice what to look for in a BMS , volts and amps ratings and such, I think I want a bluetooth...