Recent content by TTSProd

I would say your assessment does make the most sense. After riding all week there doesn’t seem to be any lasting effects that would indicate anything was permanently damaged. Just a bit of corrupted data I guess. If I have inexplicable stuff like this happen in the future my first step will...

All fixed! I reloaded my previous settings last night and this morning it was working. Before I reloaded my settings I read the current setting from the CA and took a screen shot. You were correct, there was no evident change in the settings that I can see after reloading, the only difference...

I don’t use presets so I have none programmed in. I used the Erider (not Erider T-9) preset to configure the torque sensor. I noticed on the product page it is listed at a 2 wire quadrature, but the preset selects 1 wire and with that setting I can see the P and D arrows toggling as I rotate...

Thanks for the reply, I just went and checked and it’s in Pass-Thru Throttle Mode. Does it need to be in current or power mode for the torque sensor to work? I could be wrong but I believe I was running in Pass-Through mode before it stopped working.

Hi, I have a Cycle Analyst with an Erider T-17 torque sensor and a Phaserunner controller. System was working great until a week ago when the Cycle Analyst stopped responding to the torque sensor input. I can see on the diagnostic screen on the CA that the torque sensor itself is still...