Recent content by zeroonea

Hi everyone, Im using fvt 120A and gt3c to control my esk8. My problem is the brake. It only brake when I currently press the trigger and quickly push trigger up. When board in momemtum, trigger at neutral position, push trigger up does not brake.

I want to build 6s4p 18650 pack. I will not use bms. I will using imax b6 to charge it with balance port. So I need help to soldering 6s4p pack with those balancing wires. A diagram would be great

I have 120A ESC and motor 6368 with spec: Tested with 24V voltage: Load current: 20.0A Power: 480W Max current: 60A Max power: 1440W I will use LG GH2, seem 2p will give only 40A. Is it will burn the battery pack at max speed?

My ESC just 6S, can you recommend gear for best performance and efficiency? I don't required it must run too fast

People say when motor very hot and ESC just warm. it is undergeared, so we should change the pinion to more teeth. Is it right?

280KV, wheel diameter is 20cm, I don't know my top speed... Can you explain what is undergeared and overgeared please?

My motor is outrunner brushless 6063 with 6S 40C battery. My ESC is 90A esc. Gear ratio is 12T/55T. I hear someone say it is undergeared or overgeared. What is undergeared and overgeared?

Is it work if I place hall sensor facing to magnet like picture below? I cannot put it in between teeth because hall sensor bigger than the gap.

Nevermind, I figured out. Another question: Is it work if I place hall sensor facing to magnet like picture below? I cannot put it in between teeth because hall sensor bigger than the gap.

I figured out each pin on ESC board, thankyou.

Hello, how to wire 3 hall sensor for 6pin ESC board? My ESC board has 6pin port for hall sensors. I don't know how to wire them. Usually wiring 3 hall sensors will have 5pin.

I have voltmeter. It has black and red wires. Where I should point red and black needle?

my FVT sleeping lion 120A has a 6pin port for hall sensors. Usually 3 hall sensors wiring will have 5 pin

it's works :D

hello, I'm using FVT 120A with thumb throttle and servo tester. They work well, except the motor only rotate when I press to half way of thumb throttle. What wrong?