Search results

Date Relevance Most replies

  1. F

    10S custom skate ESC: testers wanted!

    Hi everybody! I was quite busy the last week so I had no time to write here. I hope I don't scramble up the thread since it already continued with other topics. Yes, it's exactly this motor. OK, thanks for this explanation. I thought as long as the motor does not overheat it's no problem to...
  2. F

    10S custom skate ESC: testers wanted!

    Thanks everybody!! Yes, maybe overvoltage is the problem. I had a 2000uF/63V Nichicon capacitor placed in the same way as on the Onloop BETA batch. So approx 2-3cm away from pcb connecting points. The VESC failed at full throttle in current mode and was still accelerating. It felt a bit like...
  3. F

    10S custom skate ESC: testers wanted!

    Hi everybody Thanks for your answers. The motor is an EMAX GT5345/09 with 170KV. The error occured at around 9000 ERPM in sensorless mode, so I don't think it's the reported KV limit. I left the temp limit as default at 80°C start and 100°C end for the current limiting. But as mentioned the...
  4. F

    10S custom skate ESC: testers wanted!

    No, I got my VESC from Vedders batch. It shows me 80A on the real time graph, so I think the current seen by VESC is 80A. I have another VESC from the Enertion Beta here, but before I use it I have to change the capacitors and burn the bootloader to it. I hope I can do that this week.
  5. F

    10S custom skate ESC: testers wanted!

    Hi everyone! Yesterday after about 3-5 seconds with a constant load of 80 A on 12s batteries my VESC died. The temperatures weren't too high. I can still power it up and connect to the PC, no Fault code is shown. Pushing the throttle results the ERPM to go up to around 300 and the graph shows a...
  6. F

    Adding Hall sensors for VESC?

    Hi @vedder: Thanks for the quick reply. I thought a bit about what the problem could be: As is said, one of my hall sensors is not positioned perfectly in the center of the slot. Shouldn't this lead to the problem that the timings are not symetric on direction change? So different timings...
  7. F

    Adding Hall sensors for VESC?

    Hi I'm using VESC with E-MAX GT5345/09 170KV outrunner. Since I had some problems with cogging i added hall sensors inside the slots with 120 deg spacing. First I only used the motor in one direction and everything worked fine. But when I started to drive motor in reverse direction I noticed...
Back
Top