Search results

Date Relevance Most replies

  1. B

    Help troubleshooting Negative Hwatts from Erider BB CA3

    Running around the trike,a I meant by using the full length of cable instead of wrapping it and tucking it some where. BTW, thanks.
  2. B

    Help troubleshooting Negative Hwatts from Erider BB CA3

    It works, apparently running the software to the Phaserunner was something I was supposed to do first. Now all I need to do is figure out how to set it for a spinner cyclist not a masher. Brian PS was just about to see if I could delete the above posts, the heat must be getting to me.
  3. B

    Help troubleshooting Negative Hwatts from Erider BB CA3

    Setup is as follows. GMAC 10 with LT end. Phaserunner LT with MT60 to anderson connector 8X Ligo batteries Throttle with extension cable running around the trike instead of coiling/wrapping with zip ties CA3.14 with built in multi function switch E-rider bb 68 5 with extension (wrapped in...
  4. B

    Help troubleshooting Negative Hwatts from Erider BB CA3

    I am still trying to figure out how to use my Erider bottom bracket torque sensor. I have an aluminum frame, I have not clipped the wire to the frame. I am running it up with cables from controller and throttle to the CA 3.14. Where the cables are all wrapped in a velcro sleeve just below the CA...
  5. B

    non-oval rings on a pedal assist e-bike (was: Human watts, Erider and Cycle Analyst)

    Man do I ever screw up on this site. Yes, I meant to say oval. I have 53/39 Qrings, and I am getting a bottom bracket that measures human watts. I am curious if the non-round rings will change the human watt readings. BTW, when I did a search to see if there was a post on this I used the Qring...
  6. B

    non-oval rings on a pedal assist e-bike (was: Human watts, Erider and Cycle Analyst)

    Hey all Before I get back to rocking on my newly minted e-trike. I am going to ask if anyone has any experience with non-oval rings on a pedal assist e-bike? Brian (moderator edit: changed title to "non-oval rings on a pedal assist e-bike" from "Human watts, Erider and Cycle Analyst", since...
  7. B

    What size wrench is required for M10 sirloc nuts?

    Mostly flat. And the wheel is a 26in trike. I am only getting it for assist, not throttle. If I can put in 150 human watts, I can get the mileage I am looking for. (fingers crossed). Brian
  8. B

    What size wrench is required for M10 sirloc nuts?

    Yes, not sure where my brain was when I wrote sirloc. Brian
  9. B

    What size wrench is required for M10 sirloc nuts?

    I bought a kit from Grin (thanks Justin) and expecting it in a few weeks. As I am healing from a broken leg, I am not in a complete hurry. The motor I chose is a GMAC 10, as I am on the large Clydesdale size so I got the motor used for cargo bikes. ;-) Brian. PS since I am putting in on a...
  10. B

    What size wrench is required for M10 sirloc nuts?

    I think that is what my memory calls the nylon bushing inside a nut. Now that I am being question on it, maybe that's the binding that goes around binding project books. Now, I don't know anymore. Brian
  11. B

    What size wrench is required for M10 sirloc nuts?

    Hey all, I will be getting a ebike motor soon, shipping has been started. I am wondering what size wrench will a nut that goes over a M10 bolt is? Will I need a 17mm spanner? B
Back
Top