What I want is the round kind with 8 sizes. These are marked with the gauge sizes and there are a least 2 standards. So lets git of that. Mark them with the inch size and the metric size. I would like a .127 .130 .136 and .156. I don’t know what the 13 gauge standard is but I would like those and one more 12 gauge size if they exist. If not Wald made a spoke wrench which I never used because it was smaller that .127. These are easy to make. Just buy a tube cut if off and mill 8 slots. A torx will greatly increase the cost so an alternate wrench can be made for those who want them.