I am currently ramping up to start my motorcycle conversion. I am using a '96 Kawasaki ZX600 roller chassis along with some bits from an electric car I picked up.
I am going to start with the battery as all of my other components are tailored to this and the controller. I've been discussed with a fellow member on here about these items and what my charger can hold and produce.
I am using A123 26650 LiFePo4 batteries I picked up on a trade. A deal I couldn't pass up. I configured the system to be a 32S 15P set up and to fit it in the area, I am doing the serious connection as a folded set. The photo below shows along with the battery diagram.
My question is, what parallel connections am I needing as far as the length of the battery pack? I have 2 photos. Both the same battery packs. One is blank for anyone to drawer on it and help with some feed back and the other is what I am thinking for the parallel set up.
Also, for the BMS, I am using the ZEVA EVS modules. I have 3 units (Each able to have 12 series connections) so the last unit will only have 8 connections and room to grow the pack if needed. Where and how do I connect those wires for the BMS.
Any thoughts would help greatly.
I am going to start with the battery as all of my other components are tailored to this and the controller. I've been discussed with a fellow member on here about these items and what my charger can hold and produce.
I am using A123 26650 LiFePo4 batteries I picked up on a trade. A deal I couldn't pass up. I configured the system to be a 32S 15P set up and to fit it in the area, I am doing the serious connection as a folded set. The photo below shows along with the battery diagram.
My question is, what parallel connections am I needing as far as the length of the battery pack? I have 2 photos. Both the same battery packs. One is blank for anyone to drawer on it and help with some feed back and the other is what I am thinking for the parallel set up.
Also, for the BMS, I am using the ZEVA EVS modules. I have 3 units (Each able to have 12 series connections) so the last unit will only have 8 connections and room to grow the pack if needed. Where and how do I connect those wires for the BMS.
Any thoughts would help greatly.