Peterfr12
10 W
Hi all,
I purchased a 20S BMS 100A from greenbike kit. This BMS will go with a 20S14p battery. it is the first time I am building a battery so forgive me for the questions if they are dumb.
This is the diagram I have from the company:
connect 3 wires from B- to the negative port of the battery. I checked with an ohmmeter and the 3 B- port are connected on the circuit board. They have the same potential. Can I connect only one wire from B- to the cathode (second drawing) of the battery or should I really connect 3 of them to the battery? I guess because of the 100A limit I need 3 of them.
From the anode of the battery I will have to connect the + of the XT60 cable (charger) and the + of the XT90 cable (controller). Then I will have to connect the – of the XT60 cable and the – of the XT90 cable to the 3 different ports C- , not to only one port.
There is a P port but it is not in used here.
Thanks for your answers.
Best regards,
Peterfr
I purchased a 20S BMS 100A from greenbike kit. This BMS will go with a 20S14p battery. it is the first time I am building a battery so forgive me for the questions if they are dumb.
This is the diagram I have from the company:
connect 3 wires from B- to the negative port of the battery. I checked with an ohmmeter and the 3 B- port are connected on the circuit board. They have the same potential. Can I connect only one wire from B- to the cathode (second drawing) of the battery or should I really connect 3 of them to the battery? I guess because of the 100A limit I need 3 of them.
From the anode of the battery I will have to connect the + of the XT60 cable (charger) and the + of the XT90 cable (controller). Then I will have to connect the – of the XT60 cable and the – of the XT90 cable to the 3 different ports C- , not to only one port.
There is a P port but it is not in used here.
Thanks for your answers.
Best regards,
Peterfr