The shunt inside my PhaseRunner is 1ohm, 75A. I damaged my CA in a fall and trying to get by until the replacement arrives.
The PR has the two shunt wires exiting it, I have the WP connector pigtail.
I have a cheap shunt display from Amazon, without the shunt (used it on another project) It only works with .75ohm and 1.5 ohm
Is it possible or can it be as simple as using resistors in one side of the shunt feedback wires to bring the resistance to correct value and zero it?
I did what I could to google this, how ever it's not a hot topic. Or I do not know the correct terms to look it up, or it's a really stupid question.
Thank you for any help, just would be nice to have a battery gauge and ah idea in the mean time
The PR has the two shunt wires exiting it, I have the WP connector pigtail.
I have a cheap shunt display from Amazon, without the shunt (used it on another project) It only works with .75ohm and 1.5 ohm
Is it possible or can it be as simple as using resistors in one side of the shunt feedback wires to bring the resistance to correct value and zero it?
I did what I could to google this, how ever it's not a hot topic. Or I do not know the correct terms to look it up, or it's a really stupid question.
Thank you for any help, just would be nice to have a battery gauge and ah idea in the mean time