markz
100 TW
I have not been able to update the firmware on the rc charger so it can bulk charge instead of balance charge all the time.
I was soldering the balance leads, while plugged in and the unit kept saying "Voltage too Hi" while the soldering iron was on a balance lead. I smelt smoke, a long puff came out.
Another one bites the dust!
Input FET has the Shmooooo
Obviously I could not get the component label
the fet to the left, looks more like the Shmooooo'd out one
P55NF06?
GF115 V6
CHN715
ST
possible link
MOSFET P Channel
The bottom large mound of solder is the pos(+) and the top is the neg(-)
The fet to the right is
IRF 4905
I?R P717J
D4 YC
possible link
Mosfet N Channel
the fet further to the left is
MBR2060CT
048
the symbol is a G.
possible link
Schotty Diode / Rectifier
I was soldering the balance leads, while plugged in and the unit kept saying "Voltage too Hi" while the soldering iron was on a balance lead. I smelt smoke, a long puff came out.
Another one bites the dust!
Input FET has the Shmooooo
Obviously I could not get the component label
the fet to the left, looks more like the Shmooooo'd out one
P55NF06?
GF115 V6
CHN715
ST
possible link
MOSFET P Channel
The bottom large mound of solder is the pos(+) and the top is the neg(-)
The fet to the right is
IRF 4905
I?R P717J
D4 YC
possible link
Mosfet N Channel
the fet further to the left is
MBR2060CT
048
the symbol is a G.
possible link
Schotty Diode / Rectifier