Setting up Asi Bac 8000

andrewgreene

10 mW
Joined
Nov 25, 2019
Messages
22
Hello, can anyone help me getting set up with the asi 8000, preferably someone who has experience with it. Starting off, need to get the wiring diagram made for my bike setup. Looked for a wiring diagram for the asi, found one but a bit confused on it. Link below. On the 6 pin side for the hall sensors, i understand, match up the halls, brk2 should be for the motor temp sensor. However on the 16 pin side, bit confused., i got a throttle id like to wire in as well as on off ignition, possibly regen. Appreciate your time guys.




https://ibb.co/7CHZ8v2
 
Hello fellow noob here hoping this will pick up traction. Just ordered one for my qs273 build still not to sure what's necessary to get started lol
 
Just use existing thread, I got help there when I needed it.

https://endless-sphere.com/forums/viewtopic.php?t=102828
https://endless-sphere.com/forums/viewtopic.php?t=96264
 
See if you can get the BAC2000 datasheet that was publicly up on grin's website for a while. It has a much better pinout with more info. The pinout for the 2k/4k/8k is all the same. I tried one of those foreign pinouts first and then when I compared to ASI's diagram it wasn't even the same. I have a copy of that thing somewhere.
 
Back
Top