Are there any ready-made cable adapters for this type of application?
The MAC has this 3 cables / connectors:
Cable 1: Motor phase, Anderson 30A connector:
PIN 1: Yellow
PIN 2: Blue
PIN 3: Green
Cable 2: Hall sensors, Julet Z509 connector:
PIN 1: Green
PIN 2: Blue
PIN 3: Yellow
PIN 4: Black (GND)
PIN 5: Red (+5V)
Cable 3: NTC 10kOhm Temperature sensor, JST connector:
PIN 1: 0
PIN 2: Grey
MAC controller sockets
Since the Baserunner_Z9s reads the speed and thermistor
signal on the same line, and then demux them and send them to the Cycle Analyst,
could the CA display the speed also while coasting and
would it get a correct temp signal with this MAC?
Or would a Phaserunner MT be more suitable in this case?
As the Phaserunner manual states, the Phaserunner has two motor cable sockets (Motor phase, hall sensors).
The motor temp sensor cable has to be connected with the Cycle Analyst.
In this case only a Julet to JST adapter for the hall sensor cable would be needed.
Could the Phaserunner provide a correct speed signal with this setting to the CA?
The Phaserunner manual says:
"The CA’s speed signal (pin 5, yellow wire) will toggle once per electrical commutation
regardless of whether you have hall sensors connected"
Would I get a correct speed signal (also while coasting) with this MAC and the Phaserunner?
The MAC has this 3 cables / connectors:
Cable 1: Motor phase, Anderson 30A connector:
PIN 1: Yellow
PIN 2: Blue
PIN 3: Green
Cable 2: Hall sensors, Julet Z509 connector:
PIN 1: Green
PIN 2: Blue
PIN 3: Yellow
PIN 4: Black (GND)
PIN 5: Red (+5V)
Cable 3: NTC 10kOhm Temperature sensor, JST connector:
PIN 1: 0
PIN 2: Grey
MAC controller sockets
Since the Baserunner_Z9s reads the speed and thermistor
signal on the same line, and then demux them and send them to the Cycle Analyst,
could the CA display the speed also while coasting and
would it get a correct temp signal with this MAC?
Or would a Phaserunner MT be more suitable in this case?
As the Phaserunner manual states, the Phaserunner has two motor cable sockets (Motor phase, hall sensors).
The motor temp sensor cable has to be connected with the Cycle Analyst.
In this case only a Julet to JST adapter for the hall sensor cable would be needed.
Could the Phaserunner provide a correct speed signal with this setting to the CA?
The Phaserunner manual says:
"The CA’s speed signal (pin 5, yellow wire) will toggle once per electrical commutation
regardless of whether you have hall sensors connected"
Would I get a correct speed signal (also while coasting) with this MAC and the Phaserunner?