tongsheng tsdz2 + lcd sw102

Hi everybody!

I just built my second ebike - my old mtb with tongsheng, brake levelers, thumb throttle and vlcd5.



But the lcd is so robust and huge, i dont need that I was thinking about to use the cute little sw102 display:



How can I connect the brakes and throttle to this diplay? I have the flat connectors, is there any adapters?



I also read I have to flash the firmware, because this lcd is made for baffang. Is it difficult? or buggy?

Thank you!

You can find the instructions in the wiki:
https://github.com/OpenSource-EBike-firmware/TSDZ2_wiki/wiki/How-to-install-the-Flexible-OpenSource-firmware

To be able to use the SW102 display you need to open it and program it with a ST-LINK.

You cannot connect the brakes or the throttle direcly to any other display. You can either cut the wires and solder them to the display cable or buy a conversion cable like this and brakes/throttle with matching connectors:
https://www.eco-ebike.com/collections/tsdz2-accessories-parts/products/1t4-w-8-pin-female-connector-conversion-cable-for-tsdz2-w-8-pin-male-connector