Has anybody tried to pot the windings of a 3kw DD hub motor with thermally conductive epoxy/silicone?
Was there a sigificant improvement in combination with Statorade+Hubsinks compared to Statorade+Hubsinks only?
Obviously on a hub motor it is not possible to build a thermally conductive bridge to the case because the case is rotating so I guess the improvement of potted windings on a hub motor would only be minimal.
Was there a sigificant improvement in combination with Statorade+Hubsinks compared to Statorade+Hubsinks only?
Obviously on a hub motor it is not possible to build a thermally conductive bridge to the case because the case is rotating so I guess the improvement of potted windings on a hub motor would only be minimal.