Hello,
I have a YCSY165-03-48T Controller (picture attached) that I am trying to troubleshoot/replace. However, I cannot find any documentation for this speed controller online. It is part of my EWheels Bam Supreme bike, but I am 99% sure this controller/pinout also works for the Rad Rover.
The pins I am specifically interested in are the pins that go from the controller to the motor (pictures attached). My bike connects to a Bafang 750W motor (RM G060.750D). It is a 9 pin Julet connector, and I believe 3 wires are for the phases (those are in the middle), 5 hall effect sensor wires and 1 speed sensor (or temperature sensor) wire. I can tell the three phases are together in the middle, and the 5 hall effect sensors are together on the outside opposite of the speed (or maybe temperature?) sensor. However I do not know which ones are which and what voltage the signal should be at.
If someone could share this pinout that would be super helpful. Thank you!
I have a YCSY165-03-48T Controller (picture attached) that I am trying to troubleshoot/replace. However, I cannot find any documentation for this speed controller online. It is part of my EWheels Bam Supreme bike, but I am 99% sure this controller/pinout also works for the Rad Rover.
The pins I am specifically interested in are the pins that go from the controller to the motor (pictures attached). My bike connects to a Bafang 750W motor (RM G060.750D). It is a 9 pin Julet connector, and I believe 3 wires are for the phases (those are in the middle), 5 hall effect sensor wires and 1 speed sensor (or temperature sensor) wire. I can tell the three phases are together in the middle, and the 5 hall effect sensors are together on the outside opposite of the speed (or maybe temperature?) sensor. However I do not know which ones are which and what voltage the signal should be at.
If someone could share this pinout that would be super helpful. Thank you!