stryfe9998
1 µW
- Joined
- Nov 8, 2021
- Messages
- 1
Good day!
I am releatively new to ebike controllers and I have been trying to find some information on this small controller. I recently just purchased my first ebike (Metakoo M1) and the speed is limited to 15mph. I have been doing some research on controllers and it seems that there are quite a few out there but they are all basically the same. I have been looking at wiring diagrams and I have some understanding on what most of the wires are for. I recently found where the controller was kept on this ebike and I would like to know if anyone has any information on this or if someone who is much more versed in controllers can help me figure out if this controller has a speed limiter wire. On what I have seen on other controllers its usually a single white wire that is connected from controller to the bike. The only single wire I have seen is this purple one connected to red wire in the bike (seen in the pic with the green arrow) . I have tried uplugging it and powering on the bike. It does work and the PAS works as well. Is there a chance of damaging the controller by unplugging it? Any help would be great!
I am releatively new to ebike controllers and I have been trying to find some information on this small controller. I recently just purchased my first ebike (Metakoo M1) and the speed is limited to 15mph. I have been doing some research on controllers and it seems that there are quite a few out there but they are all basically the same. I have been looking at wiring diagrams and I have some understanding on what most of the wires are for. I recently found where the controller was kept on this ebike and I would like to know if anyone has any information on this or if someone who is much more versed in controllers can help me figure out if this controller has a speed limiter wire. On what I have seen on other controllers its usually a single white wire that is connected from controller to the bike. The only single wire I have seen is this purple one connected to red wire in the bike (seen in the pic with the green arrow) . I have tried uplugging it and powering on the bike. It does work and the PAS works as well. Is there a chance of damaging the controller by unplugging it? Any help would be great!