Help Identifying Battery Connector

SunCoaster

100 W
Joined
Nov 13, 2009
Messages
174
Location
Lake Oswego, Oregon
Picked up one of these 48 V surplus batteries and need to identify the male connector needed for a secure connector. Here's the battery:
https://www.electricbikestore.com/collections/parts/products/48v14ah-samsung-half-frame-battery

This was bought from:
https://jag35.com/collections/lithium-batteries (excellent value, fast delivery; $66.12 total with shipping)

Attached is an image of the battery connector. Just the first and forth terminals are used for power.
 

Attachments

  • IMG_1602.JPG
    IMG_1602.JPG
    71.5 KB · Views: 293
I saw a video of the seller trying to dismantle the battery pack and it is a pain to take apart... The connector Amberwolf found will allow the battery to remain unmodified.


docw009 said:
If you don't have the cradle for that battery, and don't plan on getting one,you could just wire an XT60 or XT90 connector on a short extension cable into the battery.
 
before ordering I would ask Grin for the spacing measurements and thicknesss of the fingers on their connector, so you can make sure it's the same as on yours. Not all the ones I have seen have the same finger / slot sizes or spacing. But it was the only one I knew I had seen that I knew where the page for it was. :)
 
Back
Top