Motor cable exit potting ?

qwerkus

10 kW
Joined
Jul 22, 2017
Messages
785
I'll probably have to swap cables on the new g0hs motor and could use some help.
1. The existing cable is very well potted. How can I best pull it out ?
2. What potting material is recommended to seal the motor cable exit ? I have rtv silicone laying around and epoxy. First one seems too weak and second one way to strong, especially if I have to change the cable again.

EDIT:

First Problem is no even the potting, but the hall pcb: how do you gurus remove it without braking the sensors ?

7.jpg
 
Back
Top