Enkidu
10 mW
Assembling my kit from Grin on my Bike Friday New World Tourist and am stymied at the TorqArm V2 install. The motor, a Shengyi SX1 came with three washers, two of which are the ones with tabs that go in the dropouts. I have one tabbed washer in the dropout as seen in photo 1. Near as I can tell the second washer shown in photo two goes between the TorqArm and the dropout. What do I do with the one with the tab (#1) and the C shaped one (#3) in photo 2? I do have a tabbed washer on the other side of the motor BTW.
Weirdly there were no instructions included with the TorqArm or on the Grin site. And there is nothing on their Youtube feed either.
Thank You
Weirdly there were no instructions included with the TorqArm or on the Grin site. And there is nothing on their Youtube feed either.
Thank You