Help !!!
Been unable to figure this one out and it's driving me bonkers......
Got a Hand-Cycle built with GMAC motor, 36v, 24 pole PAS .. Baserunner controller.
I got the regen to work well but it cuts out at 6 to 8 kph ... i want regen to go right down to 0 kph..
I have it set to 0 in the phaserunner software, same phase amps forward and regen ( 70 phase amps .. L10 version )
I have gone thru all the videos i can find, all the CA V3 menu options dozens of times.. google searched. etc.. just can't figure this one out.
anyone ?
Been unable to figure this one out and it's driving me bonkers......
Got a Hand-Cycle built with GMAC motor, 36v, 24 pole PAS .. Baserunner controller.
I got the regen to work well but it cuts out at 6 to 8 kph ... i want regen to go right down to 0 kph..
I have it set to 0 in the phaserunner software, same phase amps forward and regen ( 70 phase amps .. L10 version )
I have gone thru all the videos i can find, all the CA V3 menu options dozens of times.. google searched. etc.. just can't figure this one out.
anyone ?