Hi,
I am trying to connect to the ASI controller (picture below, marked 10-000666, 1839-45132 on a sticker). I downloaded the BACdoor PC software from a post in this forum and connected the USB cable coming out of the controller, to the PC. No luck. Battery was attached to controller and turned on via the control panel on the bike, red diod on controller light up).
Is this USB cable actually not for communication, but for supplying 5V to the controller?
Do I need the USB TTL converter mentioned in other posts even if I have got and USB cable on the controller?
What I would like to do is to remove the annoying 25km/h speed limiter.
Grateful for your advice on how to do this?
I am trying to connect to the ASI controller (picture below, marked 10-000666, 1839-45132 on a sticker). I downloaded the BACdoor PC software from a post in this forum and connected the USB cable coming out of the controller, to the PC. No luck. Battery was attached to controller and turned on via the control panel on the bike, red diod on controller light up).
Is this USB cable actually not for communication, but for supplying 5V to the controller?
Do I need the USB TTL converter mentioned in other posts even if I have got and USB cable on the controller?
What I would like to do is to remove the annoying 25km/h speed limiter.
Grateful for your advice on how to do this?