hi, bought this controller back in january but now i have the bike off the drive and on the road a fault has shown up, on the drive i can only get to 25mph then i'm out of driveway...
so i drove it in the van to some private not on the highway testing and it tops out at 30mph and the controller shuts down needing a power cycle to reset, rinse and repeat.
heres pcb photos and theres an unused socket area, i bought a plug and socket and made a lead from an old arduino serial adapter. connected to the lurx / lutx, rx light stays full on and tx light abought 50%, reversed connections, the same.
so im at a dead end....
if the images dont show then this album link should work
https://photos.app.goo.gl/5bk4XXuqKYGeGjUH6
so i drove it in the van to some private not on the highway testing and it tops out at 30mph and the controller shuts down needing a power cycle to reset, rinse and repeat.
heres pcb photos and theres an unused socket area, i bought a plug and socket and made a lead from an old arduino serial adapter. connected to the lurx / lutx, rx light stays full on and tx light abought 50%, reversed connections, the same.
so im at a dead end....
if the images dont show then this album link should work
https://photos.app.goo.gl/5bk4XXuqKYGeGjUH6